The specific Galaxy A01 SM-S111 U1 Firmware Download Package has a Stock ROM of Galaxy A01 SM-S111 U1. This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy A01 SM-S111 U1 S111DLUDU 1 ATC4_S111DLTFN1ATC4_TFA_10.0
There are various reasons to flash “Stock Firmware on Galaxy A01 SM-S111 U1“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Prerequisites:
- Supported Phone: Galaxy A01 SM-S111 U1
- Charge your mobile: You may no less than a half charge.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy A01 SM-S111 U1 Stock ROM Details:
SM-S111 U1 S111DLUDU 1 ATC4_S111DLTFN1ATC4_TFA:
Model: | SM-S111 Binary 1, U1, S1, Bit 1 |
Language: | Multi-Language |
Android version: | Android 10 |
Operator / Carrier: | Clean (without logo, operator apps) |
PDA: | S111DLUDU1ATC4 |
CSC: | S111DLTFN1ATC4 |
Size: | 1.5 GB |
One Drive | Google Drive | AFH |
How To Install Galaxy A01 SM-S111 U1 Full Firmware:
1: Download and Install the Samsung USB Driver on your computer. If a Samsung USB Driver is installed on your computer, then Skip this Step.
2: Download and extract the Galaxy A01 SM-S111 U1 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: In the Download mode, you can see a Warning Yellow Triangle Sign. In this situation, you must press the Volume Up key to continue.
6: Open Odin. Then, connect your phone to the pc.
7: After connecting the smartphone to the computer, Odin will automatically recognize the device and display the “Added” message in the lower left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy A01 SM-S111 U1 finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy A01 SM-S111 U1 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.