Galaxy S10 SC-03L U8 Firmware – Android 12 S
The specific Galaxy S10 SC-03L U8 Firmware Download Package has a Stock ROM of Galaxy S10 SC-03L U8. This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy S10 SC-03L Binary 8 Firmware – Android 12 S – DCM – SC03LOMU1DVB5
There are various reasons to flash “Stock Firmware on Galaxy S10 SC-03L U8“. For example, your Phone will be stuck or hang on the logo. You want to remove the FRP lock from it.
Suppose you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs on the Phone
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy S10 SC-03L U8
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy S10 SC-03L U8 Stock ROM Details:
SC-03L U8 Firmware – Android 12 S – DCM – SC03LOMU1DVB5:
Model | SC-03L Binary 8 U8, S8, Bit 8 |
Region / Country | Brazil |
Language | Multi-Language |
Android version | Android 12 s |
Operator / Carrier | clear |
PDA | SC03LOMU1DVB5 |
CSC | SC03LDCM1DVB5 |
MODEM CP Version | SC03LDCM1DVB5 |
product code | DCM |
Build Date | 20220217143330 |
Security Patch Level | – |
Size | 5.62 GB Full Files |
Download | Google Drive | Android File Host |
How To Install Galaxy S10 SC-03L U8 Stock Firmware:
1: Install the Samsung USB Driver on your pc.
2: Download and extract the Galaxy S10 SC-03L U8 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: After switching off the Phone, you need to boot into Download Mode. To boot into download mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message at the lower-left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once the Firmware process is completed, you can see a Green Box with a Pass written on it in Odin. During this process, the Smartphone will reboot automatically.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy S10 SC-03L U8 finally boots up, you should be running your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy S10 SC-03L U8 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.