The specific Galaxy J6 Plus SM-J610G U7 Firmware Download Package comes with a Stock ROM of Galaxy J6 Plus SM-J610G U7 Security Patch Level 2022-06-01 (June 1, 2022). This helps you to bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy J6+ SM-J610G Binary 7 Android 10 Q Mexico TCE J610GUBS7CVL4
There are various reasons to flash “Stock Firmware on Galaxy J6 Plus SM-J610G U7“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy J6 Plus SM-J610G U7
- Charge your mobile: You may no less than a half charge.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy J6 Plus SM-J610G U7 Stock ROM Details:
SM-J610G U7 Mexico TCE J610GUBS7CVL4:
Model | SM-J610G Binary 7 U7, S7, Bit 7 |
Region / Country | Mexico |
Language | Multi-Language |
Android version | Android 10 Q |
Operator / Carrier | Mexico Telcel TCE |
AP / PDA | J610GUBS7CVL4 |
CSC | J610GOWA7CVK2 |
Modem CP Version / Baseband | J610GUBS7CVL3 |
product code | TEC |
Build Date | 2022-12-07 |
Security Patch Level | 2022-06-01 (June 1, 2022) |
Size | 2.7 GB |
Download | Mega | Google Drive |
Must Read:
How To Install Galaxy J6 Plus SM-J610G U7 Stock Firmware:
1: Download and Install the Samsung USB Driver on your computer. If the Samsung USB Driver is already installed on your computer, Skip this Step.
2: Download and extract the Galaxy J6 Plus SM-J610G U7 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: In Download mode a Warning Yellow Triangle Sign appeares . Press Volume Up to proceed.
6: Now, Download and open Odin. Then connect your Smartphone to the computer.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Click the PDA button, and choose the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete the process on your Phone.
Once you see the Pass message in Odin, you can disconnect your device from the pc.
When your Galaxy J6 Plus SM-J610G U7 finally boots up, you should now be running your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy J6 Plus SM-J610G U7 Firmware“.
- Use these instructions at your own risk. We will not be responsible for everything that happens to your device, resulting from the use of the information in this guide.
- Phone must have a 70–80% charge.