The specific Galaxy A13 5G SM-A136M U2 Firmware Download Package comes with a Stock ROM of Galaxy A13 5G SM-A136M U2 Security Patch Level 2022-11-01 (November 1, 2022). This helps you to bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy A13 5G SM-A136M Binary 2 Android 13 T Panama TPA A136MUBU2BVK3
There are various reasons to flash “Stock Firmware on Galaxy A13 5G SM-A136M U2“. For example, your phone will be stuck or hang on the logo. You want to remove the FRP lock from it.
If you’re going to hard reset your phone and you cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
Galaxy A13 5G SM-A136M U2 Stock ROM Details:
|Model||SM-A136M Binary 2 U2, S2, Bit 2|
|Region / Country||Panama|
|Android version||Android 13 T|
|Operator / Operator / Carrier||Clear TPA (no logo, carrier apps)|
|AP / PDA||A136MUBU2BVK3|
|Modem CP Version / Baseband||A136MUBU2BVK3|
|Security Patch Level / Security||2022-11-01 (November 1, 2022)|
How To Install Galaxy A13 5G SM-A136M U2 Stock Firmware:
Download the Odin and USB Drivers on your PC. Follow the below link to install the firmware using the Odin Flash tool.
How To Flash Samsung Stock Firmware With ODIN
1: Download and Install Samsung USB Driver on your computer. If Samsung USB Driver is already installed on your computer, then Skip this Step.
2: Download and extract the Galaxy A13 5G SM-A136M U2 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: After switching off the phone, you need to boot into Download Mode. To boot into download mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: In the Download mode, you will be able to see a Warning Yellow Triangle Sign. In this situation, you have to press the Volume Up key to continue.
6: Now, Download and open Odin. Then connect your Smartphone to the computer.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message at the lower-left panel.
8: Once Odin detects your device, click on the PDA button, and select the Firmware.tar file.
9: Now, click on the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete the process on your Phone.
Once the Firmware process is completed you will be able to see a Green Box with Pass written on it in Odin. During this process, the Smartphone will reboot automatically.
Once you see, the Pass message in Odin, you can disconnect your Device from the computer.
The flashing process will begin and should take about 10–12 minutes. It may take some time for your device to reboot, but don’t be alarmed.
When your Galaxy A13 5G SM-A136M U2 finally boots up, you should now be running your desired firmware.
If you want to check that the correct firmware is installed, head to Settings –> About Phone –> Software Information. The firmware number is located under the “Baseband version.”