Galaxy S22 SM-S906U1 U1 Firmware – Android 12 S
The specific Galaxy S22 SM-S906U1 Binary 1 Firmware Download Package has a Stock ROM of Galaxy S22 SM-S906U1 Binary 1 ADD DATE 2022-03-23. This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy S22 SM-S906U1 Binary 1 Firmware – Android 12 S – PCT – S906U1UEU1AVC8 – Puerto Rico
There are various reasons to flash “Stock Firmware on Galaxy S22 SM-S906U1 Binary 1“. For example, your Phone will be stuck or hang on the logo. You want to remove the FRP lock from it.
Suppose you will reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs on the Phone
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy S22 SM-S906U1 Binary 1
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy S22 SM-S906U1 Binary 1 Stock ROM Details:
SM-S906U1 U1 Firmware – PCT – S906U1UEU1AVC8 – Puerto Rico:
Model | SM-S906U1 Binary 1 U1, S1, Bit 1 |
Region / Country | Puerto Rico |
Language | Multi-Language |
Android version | Android 12 S |
Operator / Carrier | Clean (no logo, operator apps) |
AP / PDA | S906U1UEU1AVC8 |
CSC | S906U1OWA1AVC8 |
MODEM CP Version | – |
product code | PCT |
Build Date | 20220313074530 |
ADD DATE | 2022-03-23 |
Size | 7.21 GB Full Files |
Download | Google Drive | Android File Host |
How To Install Galaxy S22 SM-S906U1 Binary 1 Stock Firmware:
1: Install the Samsung USB Driver on your pc.
2: Download and extract the Galaxy S22 SM-S906U1 Binary 1 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: After switching off the Phone, you need to boot into Download Mode. To boot into download mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy S22 SM-S906U1 Binary 1 finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy S22 SM-S906U1 Binary 1 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.