Home / How To / [Guide] How To Root And Install CWM On HTC Sensation XE

[Guide] How To Root And Install CWM On HTC Sensation XE


[note color=”#73ff00″]Please Read and understand the Full Gudie before Performing Any Action.[/note] [note color=”#f19e74″]Warning:- Use these instructions at your own risk. We will not be responsible for everything that happens to you or your device, resulting from the use of information in this guide.[/note] [note color=”#f1e574″]
  • This tutorial is only for HTC Sensation XE.
  • Please do not use it on any other options smartphone or tablet.
  • Make sure that the drivers for your device are installed on the computer.
  • You need to enable USB debugging mode is disabled by default.
  • Your smartphone must have a 70-80% charge.
  • Make a backup copy of important data such as call logs, SMS and other data, it is to if something goes wrong, your data is not affected [/note]

Pre Requirements To Root And Install CWM On HTC Sensation XE :-


  1. Unzip One_X_All-In-One_Kit_v1.0 , run the file X.exe One .
  2. Enable USB Debugging in Settings > Applications > Development > check USB debugging .
  3. Connect your phone to your computer.
  4. If you have not installed the drivers, select the 1.
  5. Copy the Superuser3.2RC3armsigned.zip to the root of your sd card.
  6. Rename the file recoveryclockwork- in CWM5827.img .
  7. Then copy the file CWM5827.img in the folder in One_X_All-In-One_Kit_v1.0 Data Recoveries and replace the existing file.
  8. Then, in the software panel , click CWM Touch then Flash Recovery to start the installation.
  9. The wait time of the installation. At the end of the installation, reboot your phone into recovery, either by selecting Boot into recovery column in the Commands of One_X_All-In-One_Kit or by pressing the buttons Volume Down + Power then select Recovery .
  10. Once in the recovery menu, select Install zip from sdcard . Then Choose zip from sdcard .
  11. Then select the file Superuser-3.2-RC3-arm-signed.zip and confirm on Yes .
  12. The wait time of the installation.
  13. At the end of installation, select Reboot system now by returning to the main menu of recovery.
  14. To verify that the root is activated correctly, install Root checker and perform tests root.
    One_X_All-In-One_Kit_v1 0 rar

Leave a Reply

Your email address will not be published. Required fields are marked *