Galaxy Tab S7 FE SM-T733B U1 Firmware [Full Repair]
The specific Galaxy Tab S7 FE SM-T733B U1 Firmware Download Package comes with a Stock ROM of Galaxy Tab S7 FE SM-T733B U1. This helps you to bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy Tab S7 FE SM-T733B Binary 1 Firmware – T736BXXU1AUH6 – BTU – Android 11 R
There are various reasons to flash “Stock Firmware on Galaxy Tab S7 FE SM-T733B U1“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy Tab S7 FE SM-T733B U1
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin Latest version
Galaxy Tab S7 FE SM-T733B U1 Stock ROM Details:
SM-T733B U1 Firmware – T736BXXU1AUH6 – BTU:
| Model | SM-T733B U1, Bit 1, Binary 1 |
| PDA | T736BXXU1AUH6 |
| CSC | T736BOXM1AUH6 |
| Operator / Carrier | Clean ZTO (no logo, carrier apps) |
| Product code | BTU |
| Android version | Android 11 R |
| Size | 4 GB |
| Download | Google Drive | OneDrive |
How To Install Galaxy Tab S7 FE SM-T733B U1 Stock Firmware:
1: Download and Install the Samsung USB Driver on your computer. If Samsung USB Driver is already installed on your computer, then Skip this Step.
2: Download and extract the Galaxy Tab S7 FE SM-T733B U1 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: In Download mode, a Warning Yellow Triangle Sign will appear. simply press the Volume Up key.
6: Open Odin. Then, connect your phone to the pc.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Once Odin detects your device, click on the PDA button and select the Firmware.tar file.
9: Click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete the process on your Phone.
Once you see the Pass message in Odin, you can disconnect your device from the pc.
When your Galaxy Tab S7 FE SM-T733B U1 finally boots up, you should now be running your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy Tab S7 FE SM-T733B U1 Firmware“.
- Use these instructions at your own risk.
- Phone must have a 70–80% charge.
