Yuho Netra Firmware Flash File [Stock ROM]

How To Flash Stock firmware on Yuho Netra using the SPD Upgrade Tool. If you make a hard reset and MM 8833 hang on logo then download a flash file for it without a password.

Step by step guide showing how to flash Yuho Netra stock ROM with SPD Upgrade Tool.

Why would you want to flash Stock ROM on your Yuho Netra?

There are various reasons to flash stock ROM on Yuho Netra. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.  If you’re going to reset your phone hard and you cannot access the recovery menu. But most of the problems that cause flashing stock ROM are.

• Flash Stock ROM To Unbrick
• Update and downgrade
• Unroot or fix bugs on the phone
• To solve the lag or stutter
• Fix software issues.
• Revert to stock to get your warranty
• Keeps rebooting issue
• if your phone boots straight into recovery
• Phone boots straight into its bootloader

Requirements to flash Yuho Netra Stock ROM:

• Supported Phone: Yuho Netra
• Charge your mobile: You may no less than a half charge.
• Laptop or PC.

1. Take Yuho Netra Backup

Before going to install Yuho Netra stock ROM, you need to take all your messages, photos, and apps from your current smartphone. This requires a backup that you then restore on your device after flashing firmware.

How To Backup Android Phone Before Flashing Stock Firmware

2. Download Yuho Netra Flash Tool And Drivers:

A.  Download and install Yuho Netra Drivers. The basic communication between your device and PC.

These drivers are mainly for the devices powered by SPD chipset. With these drivers, you can transfer files, flash the firmware files on the device, etc.

B. We use the SPD Upgrade Tool for as Yuho Netra Flash Tool there are different reasons why we will use Spd Flash Tool to unbrick the Yuho Netra.

I believe this tool is very efficient. Follow the step by step procedure to use the One-Click Unbrick Tool and unbrick your Yuho Netra.

Yuho Netra Stock ROM Details:

Gapps File:	Yes
Device Supported:	Yuho Netra
Tool Supported:	SPD Upgrade Tool
Soc:	Spreadtrum
Android version:	Android 9 Pie
Firmware version:	e64_xx16-uct_yuho_4lane_SMR_AndroidP_20190815
Password:	Nul

Instructions to Install Yuho Netra Firmware:

1. Install Spreadtrum Drivers.
2. Install the SPD Download Tool.
3. Open the Research download tool > bin folder.
4. Launch ResearchDownload.exe.
5. Click on the Load Packet icon (top left corner).
6. In the window that pops up, navigate to the location of the Yuho Netra Firmware.pac file, select it then click Open.
7. The PAC file should now be loaded (its name should appear at the top).
8. Click the Settings Icon (top left corner).
9. In the box that pops up, untick any item(s) you do not wish to flash then click OK. Ignore this step if you want to flash all files.
10. Click the Start downloading button.
11. You should see Waiting under the Progress bar.
12. Switch off the phone (still with battery inside) then connect it to the PC via USB cord (note that you might need to hold the volume decrease button while connecting to PC on some phones) and flashing should begin. DO NOT interrupt.
13. Once flashing is complete, you’ll see Passed.
14. Click on the Stop downloading icon then disconnect the phone from the PC and boot.