Tecno I3 Secure Boot DA File [Format Single Partition]

Format A Single Partition In Tecno I3 using Tecno I3 Secure Boot DA File. This is a step by step guide showing how to format a single partition of a Tecno I3 using SP flash tool.

Tecno I3 Secure Boot DA File

Why would I want to format a single partition on my Tecno I3?

There are different causes why one might want to format a single partition on a Tecno I3. One such example is when your device is FRP locked, all you need do is to format only FRP partition OR maybe you need to perform a factory reset but you are unable to boot into recovery mode for some weird unknown reasons, all you need is to format user data and cache partitions. The method below will show how we can do this.

Requirements to format one single partition on my Tecno I3:

  • Supported Phone: Tecno I3
  • Charge your mobile: You may no less than a half charge.
  • Laptop or PC: To execute this installation, you must use a PC or Laptop.

Take Tecno I3 Backup:

Download Tecno I3 Flashing Tool And Drivers:

Tecno I3 Secure Boot DA File Detail:

  • File Name: S4 IX626B Boot DA
  • Device Supported: Tecno I3
  • Tool Supported: Sp Flash Tool

Download

Tecno I3 Da Boot Auth File.rar

How to Format a Single Partition of Tecno I3:

1. The steps below explain how to format a single partition of a Tecno I3 using SP flash tool.

2. Extract the content of the SP flash tool zip file and Launch SP flash tool.

Launch Sp Flash Tool to Format a Single Partition of Tecno I3

3. Select the scatter file for your device by clicking choose besides the scatter-loading file’s dropdown bar.

Select scatter to Format a Single Partition of Tecno I3

4. In the windows that appear next, navigate to and select the Tecno I3 scatter file.

select the Tecno I3 scatter file

5. You should now be taken back to the SP flash tool window, click on the Format tab.

Tecno I3 Secure Boot DA File [Format Single Partition]

6. Tick the checkbox beside “Manual format flash”

Tecno I3 Manual format flash

7. Open windows explorer and navigate to the location of the scatter file you selected earlier on then open it using Notepad++

8. Scroll down the contents of the scatter file till you get to the partition you wish to format [in my case, I’m trying to format FRP partition]

Tecno I3 format FRP partition

9. Input the values of Linear_start addr and partition_size into SP flash tool then Click on Start

Code:

Linear_start addr = Begin Address
partition_size    = Format Length

Tecno I3 addr and partition_size

10. Power off the phone (with the battery in) then connect to the PC via a USB cord. Once successful, you should get a green tick.

11. Now you can boot up the Tecno I3.

Disclaimer:

  • Once SP flash tool has detected your device, avoid disconnecting till the task is complete as this might cause the Tecno I3 to go dead.
  • If you accidentally selected “Autoformat – Format all”, your device will go dead and you’ll need to flash full Tecno I3 stock ROM to revive the phone.
  • Avoid using a random Tecno I3 scatter file (even though its for your chipset) in Sp flash tool. Just because a scatter file is for your chipset doesn’t mean it contains the same partition info. Formatting with a wrong scatter file could result in more problems than you initially intended to fix.
  • SP flash tool was created by MediaTek Inc. so credits to them for the tool.

Check Also

Infinix X653C DA File

Infinix X653C DA File [Secure Boot Auth]

Format A Single Partition using Infinix X653C DA File. This is a step by step …

Leave a Reply

Your email address will not be published. Required fields are marked *