Samsung Galaxy S5 SCL23 Android 6.0.1 Official Stock Firmware Flash Files

Samsung Galaxy S5 SCL23 Android 6.0.1 Official Stock Firmware Flash Files

LGPlease Read and understand the Full Guide Before Flashing Samsung Galaxy S5 SCL23 Stock Rom.

Use these instructions at your own risk. We will not be responsible for everything that happens to you or your device, resulting from the use of information in this guide.

Make sure that the USB drivers for your device are installed on the computer.

- Advertisement -

Your smartphone must have a 70–80% charge.

Make a backup copy of important data such as call logsSMS, and other data, it is to if something goes wrong, your data is not affected.

 

You Can Use The Following Flash Files For Upgrade Samsung Galaxy S5 SCL23 Android 6.0.1 / And If You Want To Hard Reset It By Flashing The Stock ROM/ In Case If You Are Using Any Custom Rom And Want Back To Stock Rom And Official Firmware Or Facing The Boot Loop Problem. This Method Is Also Useful For Sudden Death/Bricked/Not Power And Also After Flashing The Stock Rom IMEI Null or Unknown Baseband Problems Can Be Solved.

 

How To Flash Samsung Galaxy S5 SCL23 :-

Download   USB Driver.    Odin3 v3.12.7.zip     And   SCL23KDI1DPH3 KDI MM SAMFIRM.NET.zip

[quads id=2]

Step 1: Install Samsung USB Driver on your computer. If Samsung USB Driver is already installed on your computer then Skip this Step.

Step 2: Download and extract the stock ROM files on your computer. After extracting you will be able to see the following files.

Step 3: Now, Switch off your Smartphone.

Step 4: After switching-off the phone, you need to boot into Download Mode. To boot into download mode Press and hold Volume DownHome and Power button at same time for 5-8 seconds until download mode is active.

Step 5: In the Download mode you will be able to see a Warning Yellow Triangle Sign. In this situation you have to press the Volume Up key to continue.

Step 6: Now, Open Odin 3 (found in the extracted files, that you have downloaded in the Step#2) on your computer. Then connect your Smartphone to the computer.

Step 7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show “Added” message at the lower-left panel.

Step 8: Once your device is detected by Odin, click on the PDA button and select the CF-Auto-Root.tar file (you have downloaded this file in step#2).

Step 9: Now, click on the Start button in Odin to begin the Flashing.

Step 10: Flashing usually takes 30-50 seconds to complete the rooting process on your Phone. Once Rooting process is completed you will be able to see a Green Box with Pass written on it in Odin. During this process Smartphone will re-boot automatically.

Step 11: Once you see, the Pass message in Odin, you can disconnect your Device from the computer.