Samsung Galaxy J7 SM-J700T Firmware

 

Advertisement

I am flashing stock firmware on SM-J700T using the flash tool. This is useful for the update to android 6.0.1 and solution of unknown baseband error after modem update without root. Step by step guide showing how to flash Samsung Galaxy J7 Stock ROM File with Sp flash tool.

Pre-requirements to Update Samsung Galaxy J7 SM-J700T Stock ROM Android 6.0.1

Before going to install Samsung Galaxy J7 SM-J700T stock ROM you need to take all your messages, photos, and apps from your current smartphone. This requires a backup that you then restore on your device after flashing or updating the firmware.

How To Backup Android Phone Before Ota Update

Download Samsung Galaxy J7 SM-J700T Stock ROM Android 6.0.1

  • Download Samsung Galaxy Tab A 2019 SM-T510 stock firmware:   HERE
  • Download Samsung Galaxy Tab A 2019 SM-T515 stock firmware:   HERE 

[quads id=2]

How To Install Samsung Galaxy J7 SM-J700T Stock Firmware

 1: Download and Install Samsung USB Driver on your computer. If Samsung USB Driver is already installed on your computer then Skip this Step.

2: Download and extract the Samsung Galaxy J7 SM-J700T Pie Stock Firmware files on your computer. After extracting you will be able to see the following files:

 

3: Now, Switch off your Smartphone.

 

4: After switching off the phone, you need to boot into Download Mode. To boot into download mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: In the Download mode you will be able to see a Warning Yellow Triangle Sign. In this situation, you have to press the Volume Up key to continue.

 

6: Now, Download and open Odin Open (found in the extracted files, that you have downloaded in theStep#2) on your computer. Then connect your Smartphone to the computer.

 

7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message at the lower-left panel.

8: Once your device is detected by Odin, click on the PDA button and select the Samsung Galaxy J7 SM-J700T Firmware.tar file (you have downloaded this file in step#2).

9: Click the Start button in Odin to begin the Flashing.

Step 10: Samsung Galaxy J7 SM-J700T Firmware Flashing usually takes 30-50 seconds to complete the process on your Phone.

The once Samsung Galaxy J7 SM-J700T Firmware flashing process is completed you will be able to see a Green Box with Pass written on it in Odin. During this process, the Smartphone will reboot automatically.

11: Once you see, the Pass message in Odin, you can disconnect your Device from the computer.