SM-G925W8 Binary 6

The specific Galaxy S6 Edge SM-G925W8 U6 Firmware Download Package has a Stock ROM of Galaxy S6 Edge SM-G925W8 U6 Security Patch Level 2018-06-01 (1 June 2018). This helps bypass the FRP lock and revert from the root and custom ROM.

Advertisement

Samsung Galaxy S6 Edge SM-G925W8 U6 Firmware

There are various reasons to flash “Stock Firmware on Galaxy S6 Edge SM-G925W8 U6“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-requirements:

 

Galaxy S6 Edge SM-G925W8 U6 Stock ROM Details:

Model SM-G925W8 Binary 6 (U6, S6, Bit 6)
Region / Country Canada
Language Multi-Language
Android version Android 7.0 Nougat
Operator Clean XAC (without logo, operator apps)
PDA G925W8VLU6DRF1
CSC G925W8OYA6DRF1
Product code XAC
Build Date Mon, 04 Jun 2018
Security Patch Level 2018-06-01 (1 June 2018)
Size 1.8 GB
[quads id=2]
Download 4File Google Drive Android File Host

How To Install  S6 Edge SM-G925W8 U6 Stock Firmware:

How To Flash Samsung Stock Firmware With ODIN

1: Install the Samsung USB Driver on your pc.

2: Download and extract the Galaxy S6 Edge SM-G925W8 U6 Firmware files on your computer.

3: Now, Switch off your Smartphone.

4: Turn off the phone and boot into Download Mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.

6: Open Odin. Then, connect your phone to the pc.

7: After connecting the smartphone to the computer, Odin will automatically recognize the device and display the “Added” message in the lower left panel.

8: Click the PDA button and select the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.

Once the Firmware process is completed, you will see a Green Box with a Pass written in Odin. During this process, the Smartphone will reboot automatically.

Once you see the Pass message in Odin, you can disconnect your Device from the computer.

You should run your desired firmware when your Galaxy S6 Edge SM-G925W8 finally boots up.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy S6 Edge SM-G925W8 U6 Firmware.
  • Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
  • Phone must have a 70–80% charge.