The specific Galaxy Z Flip 3 5G SM-F711U Binary 1 Firmware Download Package has a Stock ROM of Galaxy Z Flip 3 5G SM-F711U Binary 1. This helps bypass FRP lock and revert from the root and custom ROM.
Samsung Galaxy Z Flip 3 5G SM-F711U Binary 1 Repair Firmware – F711USQU1AUGB – TMB – Android 11 R
There are various reasons to flash “Stock Firmware on Galaxy Z Flip 3 5G SM-F711U Binary 1“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy Z Flip 3 5G SM-F711U Binary 1
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy Z Flip 3 5G SM-F711U U1 Stock ROM Details:
SM-F711U U1 Repair Firmware – F711USQU1AUGB – TMB:
| Model | SM-F711U U1, Bit 1, Binary 1 |
| PDA | F711USQU1AUGB |
| CSC | F711UOYN1AUGB |
| Operator / Carrier | Clean ZTO (no logo, carrier apps) |
| Product code | TMB |
| Android version | Android 11 R |
| Size | 4 GB |
| Download | Google Drive | OneDrive |
How To Install Galaxy Z Flip 3 5G SM-F711U Binary 1 Stock Firmware:
1: Install the Samsung USB Driver on your pc.
2: Download and extract the Galaxy Z Flip 3 5G SM-F711U Binary 1 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy Z Flip 3 5G SM-F711U Binary 1 finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy Z Flip 3 5G SM-F711U Binary 1 Firmware“.
- Use these instructions at your own risk. We will not be responsible for everything that happens to your device resulting from using information in this guide.
- Phone must have a 70–80% charge.
