Galaxy S10e SM-G970F U11 Firmware – G970FXXSBFUE6
The specific Galaxy S10e SM-G970F U11 Firmware Download Package has a Stock ROM of Galaxy S10e SM-G970F U11 Security Patch Level 2021-06-01 (June 1, 2021). This helps bypass FRP lock and revert from the root and custom ROM.
Samsung Galaxy S10e SM-G970F Binary 11 Android 11 R Brazil ZTO – G970FXXSBFUE6
There are various reasons to flash “Stock Firmware on Galaxy S10e SM-G970F U11“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy S10e SM-G970F U11
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin Latest version
Galaxy S10e SM-G970F U11 Stock ROM Details:
SM-G970F U11 Brazil ZTO – G970FXXSBFUE6:
Model | SM-G970F Binary 11 U11, S11, Bit 11 |
Region / Country | Brazil |
Language | Multi-Language |
Android version | Android 11 R |
Operator / Carrier | Clean ZTO (no logo, carrier apps) |
PDA | G970FXXSBFUE6 |
CSC | G970FOWOBFUE6 |
product code | ZTO |
Build Date | 25 May 2021 |
Security Patch Level | 2021-06-01 (June 1, 2021) |
Size | 4.6 GB |
Download | Google Drive | Android File Host |
How To Install Galaxy S10e SM-G970F U11 Stock Firmware:
1: Download and Install Samsung USB Driver on your computer. If a Samsung USB Driver is installed on your computer, Skip this Step.
2: Download and extract the Galaxy S10e SM-G970F U11 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Now, Download and open Odin. Then connect your Smartphone to the computer.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you see the Pass message in Odin, you can disconnect your device from the pc.
You should run your desired firmware when your Galaxy S10e SM-G970F U11 finally boots up.
If you want to check that the correct firmware is installed, head to Settings –> About Phone –> Software Information. The firmware number is located under the “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy S10e SM-G970F U11 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.