Galaxy Z Flip 3 5G SM-F711N U1 Firmware – [Full Repair]

Galaxy Z Flip 3 5G SM-F711N Binary 1 Firmware

The specific Galaxy Z Flip 3 5G SM-F711N U1 Firmware Download Package has a Stock ROM of Galaxy Z Flip 3 5G SM-F711N U1. This helps you to bypass the FRP lock and revert from the root and custom ROM.

Samsung Galaxy Z Flip 3 5G SM-F711N U1 Full Firmware – F711NKSU1AUGM – Android 11 R

There are various reasons to flash “Stock Firmware on Galaxy Z Flip 3 5G SM-F711N U1“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-requirements:

Galaxy Z Flip 3 5G SM-F711N U1 Stock ROM Details:

SM-F711N U1 Full Firmware – F711NKSU1AUGM:

Model SM-F711N U1, Bit 1, Binary 1
PDA F711NKSU1AUGM
CSC F711NOKR1AUGM
Operator / Carrier Clean ZTO (no logo, carrier apps)
Product code KOO – KTC – LUC – SKC
Android version Android 11 R
Size 4 GB
[quads id=2]
KOO OneDrive
KTC OneDrive
LUC OneDrive
SKC OneDrive

How To Install Galaxy Z Flip 3 5G SM-F711N U1 Stock Firmware:

How To Flash Samsung Stock Firmware With ODIN

1: Download and Install the Samsung USB Driver on your computer.

2: Download and extract the Galaxy Z Flip 3 5G SM-F711N U1 Firmware files on your computer.

3: Now, Switch off your Smartphone.

4: Turn off the phone and boot into Download Mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.

6: Open Odin. Then, connect your phone to the pc.

7: Odin will detect the device and show the “Added message in the lower-left panel.”.

8: Click the PDA button and select the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.

Once you spot the “Pass” message in Odin, you can unplug your device from the computer.

When your Galaxy Z Flip 3 5G SM-F711N U1 finally boots up, you should run your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy Z Flip 3 5G SM-F711N U1 Firmware.
  • Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
  • Phone must have a 70–80% charge.