The specific Galaxy Z Flip3 5G SM-F711B U2 Firmware Download Package has a Stock ROM of Galaxy Z Flip3 5G SM-F711B U2 ADD DATE 2022-03-24. This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy Z Flip3 5G SM-F711B Binary 2 Android 12 Brazil ZTO F711BXXS2CVG1
There are various reasons to flash “Stock Firmware on Galaxy Z Flip3 5G SM-F711B U2“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy Z Flip3 5G SM-F711B U2
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download
Odin’s Latest version
Galaxy Z Flip3 5G SM-F711B U2 Stock ROM Details:
SM-F711B U2 Brazil ZTO F711BXXS2CVG1:
Model | SM-F711B Binary 2 U2, S2, Bit 2 |
Region / Country | Brazil |
Language | Multi-Language |
Android version | Android 12 s |
Operator / Carrier | Clean ZTO (no logo, carrier apps) |
AP / PDA | F711BXXS2CVG1 |
CSC | F711BOWO2CVF1 |
CP Version / Baseband Modem | F711BXXU2CVF2 |
product code | ZTO |
Build Date | 2022-06-28 |
Security Patch Level | 2022-06-01 (June 1, 2022) |
Size | 6.4 GB |
Download |
How To Install Galaxy Z Flip3 5G SM-F711B U2 Stock Firmware:
1: Download and Install Samsung USB Driver on your computer. If a Samsung USB Driver is installed on your computer, Skip this Step.
2: Download and extract the Galaxy Z Flip3 5G SM-F711B U2 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Once Odin detects your device, click the PDA button, and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy Z Flip3 5G SM-F711B U2 finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy Z Flip3 5G SM-F711B U2 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.