The specific Galaxy Tab S8 Ultra 5G SM-X906C U1 Firmware Download Package comes with a Stock ROM of Galaxy Tab S8 Ultra 5G SM-X906C U1 Build Date 2022-01-13. This helps you to bypass FRP lock and revert from the root and custom ROM.
There are various reasons to flash “Stock Firmware on Galaxy Tab S8 Ultra 5G SM-X906C U1“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
How To Install Galaxy Tab S8 Ultra 5G SM-X906C U1 Stock Firmware:
1: Download and Install Samsung USB Driver on your computer. If a Samsung USB Driver is already installed on your computer, then Skip this Step.
2: Download and extract the Galaxy Tab S8 Ultra 5G SM-X906C U1 Firmwarefiles on your computer.
3: Now, Switch off your Smartphone.
4: Boot into Download Mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: In Download mode a Warning Yellow Triangle Sign appeares . Press Volume Up to proceed.
6: Now, Download and open Odin. Then connect your Smartphone to the computer.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message on the lower-left panel.
8: Click the PDA button, and choose the Firmware.tar file.
9: Click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete the process on your Phone.
Once you see the Pass message in Odin, you can disconnect your device from the pc.
When your Galaxy Tab S8 Ultra 5G SM-X906C U1 finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
Read and understand the Full Guide before flashing.”Galaxy Tab S8 Ultra 5G SM-X906C U1 Firmware“.