SM-X906B Binary 1 Firmware

The specific Galaxy Tab S8 Ultra 5G SM-X906B U1 Firmware Download Package comes with a Stock ROM of Galaxy Tab S8 Ultra 5G SM-X906B U1 Security Patch Level 2022-02-01 (February 2022). This helps bypass FRP lock and revert from the root and custom ROM.

Advertisement

Samsung Galaxy Tab S8 Ultra 5G SM-X906B Binary 1 Firmware – Android 12 S – XXV – X906BXXU1AVC5 – Vietnam

There are various reasons to flash “Stock Firmware on Galaxy Tab S8 Ultra 5G SM-X906B U1“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-requirements:

Galaxy Tab S8 Ultra 5G SM-X906B U1 Stock ROM Details:

SM-X906B U1 XXV – X906BXXU1AVC5 – Vietnam:

Model SM-X906B Binary 1 U1, S1, Bit 1
Region / Country Vietnam
Language Multi-Language
Android version Android 12 S
Operator / Carrier Clean (no logo or carrier apps)
AP / PDA X906BXXU1AVC5
CSC X906BOXM1AVC5
CP Version / Base Band Modem
product code XXV
Build Date 20220308024330
Security Patch Level
2022-02-01 (February 2022)
Size 7.94 GB Full Files
[quads id=2]
Download Google Drive Android File Host

How To Install Galaxy Tab S8 Ultra 5G SM-X906B U1 Stock Firmware:

1: Download and Install the Samsung USB Driver on your computer. If Samsung USB Driver is already installed on your computer, then Skip this Step.

2: Download and extract the  Galaxy Tab S8 Ultra 5G SM-X906B U1 Firmware  files on your computer.

3: Now, Switch off your Smartphone.

4: Turn off the phone and boot into Download Mode.

Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.

5: In the Download mode, you can see a Warning Yellow Triangle Sign. In this situation, you must press the Volume Up key to continue.

6: Open Odin. Then, connect your phone to the pc.

7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message on the lower-left panel.

8: Once Odin detects your device, click the PDA button, and select the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.

Once you spot the “Pass” message in Odin, you can unplug your device from the computer.

When your Galaxy Tab S8 Ultra 5G SM-X906B U1 finally boots up, you should run your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy Tab S8 Ultra 5G SM-X906B U1 Firmware.
  • Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
  • Phone must have a 70–80% charge.