Galaxy Tab S7 (LTE) SM-T878U Binary 2 Firmware

The specific Galaxy Tab S7 (LTE) SM-T878U U2 Firmware Download Package has a Stock ROM of Galaxy Tab S7 (LTE) SM-T878U U2 ADD DATE 2022-03-16. This helps bypass the FRP lock and revert from the root and custom ROM.

Advertisement

Samsung Galaxy Tab S7 (LTE) SM-T878U Binary 2 Firmware – Android 12 S – VZW – T878USQS2CVC1 – United States

There are various reasons to flash “Stock Firmware on Galaxy Tab S7 (LTE) SM-T878U U2“. For example, your Phone will be stuck or hang on the logo. You want to remove the FRP lock from it.

Suppose you’re going to hard reset your phone and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs on the Phone
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-requirements:

Galaxy Tab S7 (LTE) SM-T878U U2 Stock ROM Details:

SM-T878U U2 Firmware – VZW – T878USQS2CVC1 – United States:

Model SM-T878U Binary 2 U2, S2, Bit 2
Region / Country United States
Language Multi-Language
Android version Android 12 S
Operator / Carrier clear
PDA T878USQS2CVC1
CSC T878UOYN2CVC1
MODEM CP Version T878UOYN2CVC1
product code VZW
Build Date 20220307220951
ADD DATE 2022-03-16
Size 6.2 GB Full Files
[quads id=2]
Download Google Drive Android File Host

How To Install Galaxy Tab S7 (LTE) SM-T878U U2 Stock Firmware:

1: Download and Install Samsung USB Driver on your computer. If Sa amsung USB Driver is installed on your computer, Skip this Step.

2: Download and extract the  Galaxy Tab S7 (LTE) SM-T878U U2 Firmware  files on your computer.

3: Now, Switch off your Smartphone.

4: After switching off the Phone, you need to boot into Download Mode. To boot into download mode.

Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.

5: In the Download mode, you will be able to see a Warning Yellow Triangle Sign. In this situation, you hmustpress the Volume Up key to continue.

6: Now, Download and open Odin. Then connect your Smartphone to the computer.

7: Odin will detect the device and show the “Added message in the lower-left panel.”.

8: Once Odin detects your device, click the PDA button, and select the Firmware.tar file.

9: Click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete the process on your Phone.

Once you see,the Pass message in Odin, you can disconnect your Device from the computer.

The flashing process will begin and should take about 10–12 minutes. IYour devicemay take some time fo reboot, but don’t be alarmed.

When your Galaxy Tab S7 (LTE) SM-T878U U2 finally boots up, you should ne running your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy Tab S7 (LTE) SM-T878U U2 Firmware.
  • Use these instructions at your own risk.
  • Phone must have a 70–80% charge.