Galaxy S9 SM-G960U1 U7 Firmware – G960U1UES7DTE1
The Galaxy S9 SM-G960U1 Binary 7 Firmware Download Package comes with a Stock ROM of Galaxy S9 SM-G960U1 U7 Security Patch Level 2020-05-01 (1 May 2020). This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy S9 SM-G960U1 Binary 7 Android 10 Q United States USC
There are various reasons to flash “Stock Firmware on Galaxy S9 SM-G960U1 U7“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy S9 SM-G960U1 U7
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy S9 SM-G960U1 U7 Stock ROM Details:
| Model | SM-G960U1 Binary 7 U7 S7, Bit 7 |
| Region / Country | United States |
| Language | Multi-Language |
| Android version | Android 10 Q |
| Operator | Clean USC (without logo, operator apps) |
| PDA | G960U1UES7DTE1 |
| CSC | G960U1OYM7DTE1 |
| Product code | USC |
| Build Date | 06 May 2020 |
| Security Patch Level | 2020-05-01 (1 May 2020) |
| Size | 4 GB |
| Download | Google Drive | Android File Host |
How To Install Galaxy S9 SM-G960U1 U7 Stock Firmware:
1: Install the Samsung USB Driver on your pc.
2: Download and extract the Galaxy S9 SM-G960U1 U7 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: After connecting the smartphone to the computer, Odin will automatically recognize the device and display the “Added” message in the lower left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once the Firmware process is completed, you can see a Green Box with a Pass written on it in Odin. During this process, the Smartphone will reboot automatically.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
You should run your desired firmware when your Galaxy S9 SM-G960U1 finally boots up.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy S9 SM-G960U1 U7 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.
