The specific Galaxy S5 Active SM-G870F0 U1 Firmware Download Package has a Stock ROM of Galaxy S5 Active SM-G870F0 U1. This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy S5 Active SM-G870F0 U1 G870F0KOU1APG6_G870F0KOO1APG6_KOO_5.1.1
There are various reasons to flash “Stock Firmware on Galaxy S5 Active SM-G870F0 U1“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Prerequisites:
- Supported Phone: Galaxy S5 Active SM-G870F0 U1
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy S5 Active SM-G870F0 U1 Stock ROM Details:
SM-G870F0 U1 G870F0KOU1APG6_G870F0KOO1APG6_KOO:
| Model: | SM-G870F0 Binary 1, U1, S1, Bit 1 |
| Language: | Multi-Language |
| Android version: | Android 5 Lollipop |
| Operator / Carrier: | Clean (without logo, operator apps) |
| PDA: | G870F0KOU1APG6 |
| CSC: | G870F0KOO1APG6 |
| Size: | 1.5 GB |
| One Drive | Google Drive | G Drive2 |
How To Install Galaxy S5 Active SM-G870F0 U1 Stock Firmware:
1: Download and Install the Samsung USB Driver on your computer.
2: Download and extract the Galaxy S5 Active SM-G870F0 U1 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: After connecting the smartphone to the computer, Odin will automatically recognize the device and display the “Added” message in the lower left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy S5 Active SM-G870F0 finally boots up, you should now run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy S5 Active SM-G870F0 U1 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.