The specific Galaxy S22 SM-S906N U1 Firmware Download Package has a Stock ROM of Galaxy S22 SM-S906N U1 Security Patch Level 2022-04-01 (April 2022). This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy S22 SM-S906N Binary 1 Firmware – SKC S906NKSU1AVCK Android 12 S South Korea
There are various reasons to flash “Stock Firmware on Galaxy S22 SM-S906N U1“. For example, your Phone will be stuck or hang on the logo. You want to remove the FRP lock from it.
If you’re going to hard reset your Phone and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs on the Phone
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy S22 SM-S906N U1
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy S22 SM-S906N U1 Stock ROM Details:
SM-S906N U1 – SKC S906NKSU1AVCK South Korea:
| Model | SM-S906N Binary 1 U1, S1, Bit 1 |
| Region / Country | South Korea |
| Language | Multi-Language |
| Android version | Android 12 s |
| Operator / Carrier | Clean ZTO (no logo, carrier apps) |
| AP / PDA | S906NKSU1AVCK |
| CSC | S906NOKR1AVCK |
| CP Version / Baseband Modem | S906NOKR1AVCK |
| product code | SKC |
| Build Date | 20220330121831 |
| Security Patch Level | 2022-04-01 (April 2022) |
| Size | 7.32 GB Full Files |
| Download | Google Drive | Android File Host |
How To Install Galaxy S22 SM-S906N U1 Stock Firmware:
1: Download and Install the Samsung USB Driver on your computer.
2: Download and extract the Galaxy S22 SM-S906N U1 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Boot into Download Mode. To boot into download mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: In the Download mode, you can see a Warning Yellow Triangle Sign. In this situation, you must press the Volume Up key to continue.
6: Open Odin. Then, connect your phone to the pc.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message on the lower-left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy S22 SM-S906N U1 finally boots up, you should be running your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy S22 SM-S906N U1 Firmware“.
- Use these instructions at your own risk. We will not be responsible for everything that happens to your device, resulting from using infrmation in this guide.
- Phone must have a 70–80% charge.