Galaxy S22 SM-S901E U1 Firmware – Android 12

SM-S901E Binary 1 Firmware

The specific Galaxy S22 SM-S901E U1 Firmware Download Package comes with a Stock ROM of Galaxy S22 SM-S901E U1 Security Patch Level 2022-01-01 (January 1, 2022). This helps bypass FRP lock and revert from the root and custom ROM.

Samsung Galaxy S22 SM-S901E Binary 1 Android 12 Brazil ZTO S901EXXU1AVA7

There are various reasons to flash “Stock Firmware on Galaxy S22 SM-S901E U1“. For example, your Phone will be stuck or hang on the logo. You want to remove the FRP lock from it.

Suppose you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs on the Phone
  • To solve the lag or stutter
  • Fix software issues.
  • Return to stock for warranty coverage.

Pre-requirements:

Galaxy S22 SMthe -S901E U1 Stock ROM Details:

SM-S901E U1 Brazil ZTO S901EXXU1AVA7:

Model SM-S901E Binary 1 U1, S1, Bit 1
Region / Country Brazil
Language Multi-Language
Android version Android 12 S
Operator / Carrier Clean ZTO (no logo, carrier apps)
PDA S901EXXU1AVA7
CSC S901EOWO1AVA7
MODEM CP Version S901EXXU1AVA7
product code ZTO
Build Date 2022-01-10
Security Patch Level 2022-01-01 (January 1, 2022)
Size 8 GB
[quads id=2]
Download Google Drive Android File Host

How To Install Galaxy S22 SM-S901E U1 Stock Firmware:

1: Download and Install Samsung USB Driver on your computer. If a Samsung USB Driver is installed on your computer, Skip this Step.

2: Download and extract the Galaxy S22 SM-S901E U1 Firmware files on your computer.

3: Now, Switch off your Smartphone.

4: After switching off the Phone, you need to boot into Download Mode. To boot into download mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: In Download mode, a Warning Yellow Triangle Sign will appear. simply press the Volume Up key.

6: Now, Download and open Odin. Then connect your Smartphone to the computer.

7: Odin will detect the device and show the “Added message in the lower-left panel.”.

8: Click the PDA button and select the Firmware.tar file.

9: Click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.

Once you see the Pass message in Odin, you can disconnect your device from the pc.
The flashing process will begin and should take about 10–12 minutes. Your device takes some time to reboot, but don’t be alarmed.

When your Galaxy S22 SM-S901E U1 finally boots up, you should now be running your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy S22 SM-S901E U1 Firmware.
  • Use these instructions at your own risk.
  • Phone must have a 70–80% charge.

About Gadget Modder

Born as techie and was always focused on Android, ever since the HTC Dream was introduced. The abundance of options at his disposal in the open-source environment always seemed to pique his interest. "Blogger by choice, MBA by trade."