Galaxy S10+ SM-G975F U10 Firmware – G975FXXUAFUE3

Galaxy S10+ SM-G975F Binary 10 Firmware

Galaxy S10+ SM-G975F starts receiving an update with One UI 3.1. Updates are arriving in several countries, the Galaxy S10+ SM-G975F U10 Firmware is receiving One UI 3.1, and it is news in many regions, including Brazil, a novelty that brings the security patch of 2021-05-01 (May 1, 2021).

Samsung Galaxy S10+ SM-G975F Binary 10 Android 11 R Brazil ZTO – G975FXXUAFUE3

There are various reasons to flash “Stock Firmware on Galaxy S10+ SM-G975F U10“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-prerequisites:

Galaxy S10+ SM-G975F U10 Stock ROM Details:

SM-G975F U10 Brazil ZTO – G975FXXUAFUE3:

Model SM-G975F Binary 10 U10, S10, Bit 10
Region / Country Brazil
Language / Language Multi-Language
Android version Android 11 R
Operator / Carrier Clean ZTO (no logo, carrier apps)
PDA G975FXXUAFUE3
CSC G975FOWOAFUE3
MODEM CP Version G975FXXUAFUE1
product code ZTO
Build Date 07 May 2021
Security Patch Level 2021-05-01 (May 1, 2021)
Size 4.7 GB
[quads id=2]
Download Google Drive Android File Host

How To Install Galaxy S10+ SM-G975F U10 Stock Firmware:

1: Download and Install Samsung USB Driver on your computer. If a Samsung USB Driver is already installed on your computer, then Skip this Step.

2: Download and extract the Galaxy S10+ SM-G975F U10 Firmware files on your computer.

3: Now, Switch off your Smartphone.

4: Turn off the phone and boot into Download Mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: In Download mode a Warning Yellow Triangle Sign appeares . Press Volume Up to proceed.

6: Open Odin. Then, connect your phone to the pc.

7: Odin will detect the device and show the “Added message in the lower-left panel.”.

8: Once Odin detects your device, click the PDA button, and select the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once the Firmware process is done, a Green Box with “Pass” will appear in Odin. The Smartphone will reboot automatically.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.

When your Galaxy S10+ SM-G975F finally boots up, you should run your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy S10+ SM-G975F U10 Firmware.
  • Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
  • Phone must have a 70–80% charge.