Galaxy S10 + SM-G975F U6 Firmware File [Stock ROM]

Galaxy S10 + SM-G975F Binary 6

The specific Galaxy S10 + SM-G975F U6 Firmware Download Package comes with a Stock ROM of Galaxy S10 + SM-G975F U6 Security Patch Level  2020-06-01 (1 June 2020). This helps you to bypass the FRP lock and revert from the root and custom ROM.

Galaxy S10 Plus SM-G975F Binary 6 Android 10 Q – G975FXXS6CTE6

There are various reasons to flash “Stock Firmware on Galaxy S10 + SM-G975F U6“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-requirements:

Galaxy S10 + SM-G975F U6 Stock ROM Details:

Model SM-G975F Binary 6 U6, S6, Bit 6
Region / Country Brazil
Language Multi-Language
Android version Android 10 Q
Operator Clean ZTO (without logo, operator apps)
PDA G975FXXS6CTE6
CSC G975FOWO6CTE6
Product code ZTO
Build Date 15 May 2020
Security Patch Level 2020-06-01 (1 June 2020)
Size 4.4 GB
[quads id=2]
Download Google Drive Android File Host

How To Install Galaxy S10 + SM-G975F U6 Stock Firmware:

How To Flash Samsung Stock Firmware With ODIN

1: Install the Samsung USB Driver on your pc.

2: Download and extract the Galaxy S10 + SM-G975F U6 Firmware files on your computer.

3: Now, Switch off your Smartphone.

4: Turn off the phone and boot into Download Mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: In the Download mode, you can see a Warning Yellow Triangle Sign. In this situation, you must press the Volume Up key to continue.

6: Open Odin. Then, connect your phone to the pc.

7: Odin will detect the device and show the “Added message in the lower-left panel.”.

8: Click the PDA button and select the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.

Once you spot the “Pass” message in Odin, you can unplug your device from the computer.

When your Galaxy S10 + SM-G975F U6 finally boots up, you should now be running your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy S10 + SM-G975F U6 Firmware.
  • Use these instructions at your own risk. We will not be responsible for everything that happens to your device resulting from using information in this guide.
  • Phone must have a 70–80% charge.