Galaxy Note10+ SM-N975U1 Binary 7 Firmware
The specific Galaxy Note10+ SM-N975U1 U7 Firmware Download Package comes with a Stock ROM of Galaxy Note10+ SM-N975U1 U7. This helps you to bypass FRP lock and revert from the root and custom ROM.

Samsung Galaxy Note10 Plus SM-N975U1 256GB Binary  7 Firmware – VZW – N975U1UES7FUK1

There are various reasons to flash “Stock Firmware on Galaxy Note10+ SM-N975U1 U7“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

Advertisement

If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-requirements:

Galaxy Note10+ SM-N975U1 U7 Stock ROM Details:

  • SM-N975U1_VZW_N975U1UES7FUK1_fac.zip
    Server: Google Drive | Sever: Androidfilehost
[quads id=2]

How To Install Galaxy Note10+ SM-N975U1 U7 Stock Firmware:

1: Download and Install the Samsung USB Driver on your computer.

2: Download and extract the Galaxy Note10+ SM-N975U1 U7 Firmware files on your computer.

3: Now, Switch off your Smartphone.

4: Turn off the phone and boot into Download Mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.

6: Open Odin. Then, connect your phone to the pc.

7: Odin will detect the device and show the “Added message in the lower-left panel.”.

8: Click the PDA button and select the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.

Once you spot the “Pass” message in Odin, you can unplug your device from the computer.

When your Galaxy Note10+ SM-N975U1 U7 finally boots up, you should run your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy Note10+ SM-N975U1 U7 Firmware.
  • Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
  • Phone must have a 70–80% charge.