The specific Galaxy Note10+ 5G SM-N976B U8 Firmware Download Package has a Stock ROM of Galaxy Note10+ 5G SM-N976B U8 latest Security Patch. This helps bypass the FRP lock and revert from the root and custom ROM.
There are various reasons to flash “Stock Firmware on Galaxy Note10+ 5G SM-N976B U8“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
How To Install Galaxy Note10+ 5G SM-N976B U8 Stock Firmware:
1: Install the Samsung USB Driver on your pc.
2: Download and extract the Galaxy Note10+ 5G SM-N976B U8 Firmwarefiles on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Now, Download and open Odin. Then connect your Smartphone to the computer.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message on the lower-left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy Note10+ 5G SM-N976B U8 finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
Read and understand the Full Guide before flashing.”Galaxy Note10+ 5G SM-N976B U8 Firmware“.
Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.