The specific Galaxy Note 10+ SM-N976B U6 Firmware Download Package has a Stock ROM of Galaxy Note 10+ SM-N976B U6 Security Patch Level 2020-12-01 (1 Dezembro 2020). This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy Note 10+ SM-N976B U6 Firmware
There are various reasons to flash “Stock Firmware on Galaxy Note 10+ SM-N976B U6“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
How To Install Galaxy Note 10+ SM-N976B U6 Stock Firmware:
1: Install the Samsung USB Driver on your pc.
2: Download and extract the Galaxy Note 10+ SM-N976B U6 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: After connecting the smartphone to the computer, Odin will automatically recognize the device and display the “Added” message in the lower left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the “Pass” message in Odin, you can unplug your device from the computer.
When your Galaxy Note 10+ SM-N976B U6 finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
Read and understand the Full Guide before flashing.”Galaxy Note 10+ SM-N976B U6 Firmware“.
Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.