The specific Galaxy Note 10 Lite SM-N770F U4 Firmware Download Package has a Stock ROM of Galaxy Note 10 Lite SM-N770F U4 Security Patch Level 2020-07-01 (1 July 2020). This helps bypass FRP lock and revert from the root and custom ROM.
Samsung Galaxy Note 10 Lite SM-N770F U4 Firmware
There are various reasons to flash “Stock Firmware on Galaxy Note 10 Lite SM-N770F U4“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy Note 10 Lite SM-N770F U4
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download
Odin’s Latest version
Galaxy Note 10 Lite SM-N770F U4 Stock ROM Details:
Model | SM-N770F Binary 4 U4, S4, Bit 4 |
Region / Country | Brazil |
Language | Multi-Language |
Android version | Android 10 Q |
Operator | Clean ZTO (without logo, operator apps) |
PDA | N770FXXU4BTG7 |
CSC | N770FOWO4BTG2 |
Product code | ZTO |
Build Date | Tue, 07 Jul 2020 |
Security Patch Level | 2020-07-01 (1 July 2020) |
Size | 4.6 GB |
Download |
Download Galaxy Note 10 Lite SM-N770F U4 Boot.img
Download boot.img Note 10 Lite SM-N770F N770FXXU4BTG7 to root on Magisk
Download |
How To Install Galaxy Note 10 Lite SM-N770F U4 Stock Firmware:
1: Download and Install Samsung USB Driver on your computer. If Samsung USB Driver is installed on your computer, Skip this Step.
2: Download and extract the Galaxy Note 10 Lite SM-N770F U4 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: In Download mode a Warning Yellow Triangle Sign appeares . Press Volume Up to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Click the PDA button, and choose the Firmware.tar file.
9: Click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you see the Pass message in Odin, you can disconnect your device from the pc.
When your Galaxy Note 10 Lite SM-N770F finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy Note 10 Lite SM-N770F U4 Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.