Galaxy J7 SM-J700F Binary 3 Firmware

The specific Galaxy J7 SM-J700F U3 Firmware Download Package comes with a Stock ROM of Galaxy J7 SM-J700F U3 Security Patch Level 2017-01-01 (1 January 2017). This helps you to bypass the FRP lock and revert from the root and custom ROM.

Advertisement

Samsung Galaxy J7 SM-J700F Binary 3 Android 6.0.1 Marshmallow India INS – J700FXXU3BQA2

There are various reasons to flash “Stock Firmware on Galaxy J7 SM-J700F U3“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

If you’re going to hard reset your phone and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Prerequisites:

Galaxy J7 SM-J700F U3 Stock ROM Details:

SM-J700F U3 India INS – J700FXXU3BQA2:

Model SM-J700F Binary 3 U3, S3, Bit 3
Region / Country India
Language Multi-Language
Android version Android 6.0.1 Marshmallow
Operator Clean INS (without logo, operator apps)
PDA J700FXXU3BQA2
CSC J700FODD3BPJ2
Product code INS
Build Date Mon, 16 Jan 2017
Security Patch Level 2017-01-01 (1 January 2017)
Size 1.1 GB
[quads id=2]
2File Google Drive Android File Host

How To Install Galaxy J7 SM-J700F U3 Stock Firmware:

1: Download and Install the Samsung USB Driver on your computer.

2: Download and extract the Galaxy J7 SM-J700F U3 Firmware files on your computer.

3: Now, Switch off your Smartphone.

4: Turn off the phone and boot into Download Mode.

Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.

5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.

6: Open Odin. Then, connect your phone to the pc.

7: After connecting the smartphone to the computer, Odin will automatically recognize the device and display the “Added” message in the lower left panel.

8: Click the PDA button and select the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete on your Phone.

Once you spot the “Pass” message in Odin, you can unplug your device from the computer.

You should run your desired firmware when your Galaxy J7 SM-J700F U3 finally boots up.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy J7 SM-J700F U3 Firmware.
  • Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
  • Phone must have a 70–80% charge.