Galaxy J7 Pop (AT&T) SM-J727A U8 Firmware – Android 8 Oreo

SM-J727A Binary 8 Firmware

The specific Galaxy J7 Pop (AT&T) SM-J727A U8 Firmware Download Package comes with a Stock ROM of Galaxy J7 Pop (AT&T) SM-J727A U8. This helps you to bypass the FRP lock and revert from the root and custom ROM.

Samsung Galaxy J7 Pop (AT&T) SM-J727A Binary 8 Firmware – Android 8 Oreo – ATT – J727AUCS8BTH1

There are various reasons to flash “Stock Firmware on Galaxy J7 Pop (AT&T) SM-J727A U8“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.

The Advantages Of Stock ROM:

  • Fix boot loop issue
  • Update and Downgrade
  • Unroot or Fix Bugs
  • To solve the lag or stutter
  • Fix software issues.
  • Revert to stock firmware

Pre-requirements:

Galaxy J7 Pop (AT&T) SM-J727A U8 Stock ROM Details:

SM-J727A U8 – Android 8 Oreo – ATT – J727AUCS8BTH1:

Model SM-J727A Binary 8 U8, S8, Bit 8
Region / Country United States
Language Multi-Language
Android version Android 12 S
Operator / Carrier Clean (no logo, carrier apps)
AP / PDA X906BXXU2AVG9
CSC X906BOXM2AVG8
CP Version / Baseband Modem
product code ATT
Build Date
Security Patch Level
Size 1.91 GB Full Files
[quads id=2]
Download Google Drive Mega

How To Install Galaxy J7 Pop (AT&T) SM-J727A U8 Stock Firmware:

1: Download and Install the Samsung USB Driver on your computer.

2: Download and extract the  Galaxy J7 Pop (AT&T) SM-J727A U8 Firmware  files on your computer.

3: Now, Switch off your Smartphone.

4: Boot into Download Mode.

Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.

5: In Download mode, a Warning Yellow Triangle Sign will appear. simply press the Volume Up key.

6: Now, Download and open Odin. Then connect your Smartphone to the computer.

7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message on the lower-left panel.

8: Click the PDA button, and choose the Firmware.tar file.

9: Now, click the Start button in Odin to begin the Flashing.

10: Flashing usually takes 30-50 seconds to complete the process on your Phone.

Once you see the Pass message in Odin, you can disconnect your device from the pc.

When your Galaxy J7 Pop (AT&T) SM-J727A U8 finally boots up, you should now be running your desired firmware.

To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”

Disclaimer:

  • Read and understand the Full Guide before flashing.”Galaxy J7 Pop (AT&T) SM-J727A U8 Firmware.
  • Use these instructions at your own risk.
  • Phone must have a 70–80% charge.

Leave a Reply

Your email address will not be published. Required fields are marked *