The specific Galaxy J7 Pop (AT&T) SM-J727A U8 Firmware Download Package comes with a Stock ROM of Galaxy J7 Pop (AT&T) SM-J727A U8. This helps you to bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy J7 Pop (AT&T) SM-J727A Binary 8 Firmware – Android 8 Oreo – ATT – J727AUCS8BTH1
There are various reasons to flash “Stock Firmware on Galaxy J7 Pop (AT&T) SM-J727A U8“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy J7 Pop (AT&T) SM-J727A U8
- Charge your mobile: You may no less than a half charge.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin’s Latest version
Galaxy J7 Pop (AT&T) SM-J727A U8 Stock ROM Details:
SM-J727A U8 – Android 8 Oreo – ATT – J727AUCS8BTH1:
Model | SM-J727A Binary 8 U8, S8, Bit 8 |
Region / Country | United States |
Language | Multi-Language |
Android version | Android 12 S |
Operator / Carrier | Clean (no logo, carrier apps) |
AP / PDA | X906BXXU2AVG9 |
CSC | X906BOXM2AVG8 |
CP Version / Baseband Modem | – |
product code | ATT |
Build Date | – |
Security Patch Level | – |
Size | 1.91 GB Full Files |
Download | Google Drive | Mega |
How To Install Galaxy J7 Pop (AT&T) SM-J727A U8 Stock Firmware:
1: Download and Install the Samsung USB Driver on your computer.
2: Download and extract the Galaxy J7 Pop (AT&T) SM-J727A U8 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Boot into Download Mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: In Download mode, a Warning Yellow Triangle Sign will appear. simply press the Volume Up key.
6: Now, Download and open Odin. Then connect your Smartphone to the computer.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message on the lower-left panel.
8: Click the PDA button, and choose the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete the process on your Phone.
Once you see the Pass message in Odin, you can disconnect your device from the pc.
When your Galaxy J7 Pop (AT&T) SM-J727A U8 finally boots up, you should now be running your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy J7 Pop (AT&T) SM-J727A U8 Firmware“.
- Use these instructions at your own risk.
- Phone must have a 70–80% charge.