Galaxy J3 Top SM-J337V U11 Firmware – Android 9 Pie
The specific Galaxy J3 Top SM-J337V U11 Firmware Download Package has a Stock ROM of Galaxy J3 Top SM-J337V U11. This helps bypass FRP lock and revert from the root and custom ROM.
Samsung Galaxy J3 Top SM-J337V Binary 11 Firmware – VZW – J337VVRUBBUL1 – Android 9 Pie – United State
There are various reasons to flash “Stock Firmware on Galaxy J3 Top SM-J337V U11“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and you cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy J3 Top SM-J337V U11
- Ensure it's at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install the Samsung USB Driver
- Download Odin's Latest version
Galaxy J3 Top SM-J337V U11 Stock ROM Details:
SM-J337V U11 Firmware - VZW - J337VVRUBBUL1 United State:
Model | SM-J337V Binary 11 U11, S11, Bit 11 |
Region / Country | United State |
Language | Multi-Language |
Android version | Android 9 Pie |
Operator / Carrier | Clean (no logo, operator apps) |
PDA | J337VVRUBBUL1 |
CSC | J337VVZWBBUL1 |
MODEM CP Version | - |
product code | VZW |
Build Date | 20220111024110 |
Security Patch Level | - |
Size | 2.56 GB Full Files |
Download | Google Drive | Android File Host |
How To Install Galaxy J3 Top SM-J337V U11 Stock Firmware:
1: Install the Samsung USB Driver on your pc.
2: Download and extract the Galaxy J3 Top SM-J337V U11 Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the "Added" message at the lower-left panel.
8: Click the PDA button and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you spot the "Pass" message in Odin, you can unplug your device from the computer.
You should run your desired firmware when your Galaxy J3 Top SM-J337V U11 finally boots up.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing."Galaxy J3 Top SM-J337V U11 Fir" ware."
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.