The specific Galaxy J1 Ace SM-J111M Firmware Download Package comes with a Stock ROM of Galaxy J1 Ace SM-J111M. This helps bypass the FRP lock and revert from the root and custom ROM.
Samsung Galaxy J1 Ace SM-J111M Android 5.1.1 Lollipop Peru PET – J111MUBU0ARC1
There are various reasons to flash “Stock Firmware on Galaxy J1 Ace SM-J111M“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
- Fix boot loop issue
- Update and Downgrade
- Unroot or Fix Bugs
- To solve the lag or stutter
- Fix software issues.
- Revert to stock firmware
Pre-requirements:
- Supported Phone: Galaxy J1 Ace SM-J111M
- Ensure it’s at least 50% charged.
- Laptop or PC.
- Backup Android Phone
- Download and install Samsung USB Driver
- Download
Odin’s Latest version
Galaxy J1 Ace SM-J111M Stock ROM Details:
Model | SM-J111M |
Region / Country | Peru |
Language | Multi-Language |
Android version | Android 5 Lollipop |
Operator | Clean PET (without logo, operator apps) |
PDA | J111MUBU0ARC1 |
CSC | J111MUWA0ARC1 |
MODEM / CP version | J111MUBU0AQF1 |
Build Date | 2018-03-01 |
Product code | PET |
Size | 1.1 GB |
Download |
How To Install Galaxy J1 Ace SM-J111M Stock Firmware:
How To Flash Samsung Stock Firmware With ODIN
1: Download and Install Samsung USB Driver on your computer. If Samsung USB Driver is installed on your computer, Skip this Step.
2: Download and extract the Galaxy J1 Ace SM-J111M Firmware files on your computer.
3: Now, Switch off your Smartphone.
4: Turn off the phone and boot into Download Mode.
Press and hold Volume Down, Home and Power button at the same time for 5-8 seconds until download mode is active.
5: A Warning Yellow Triangle Sign appears in Download mode. Press the Volume Up key to proceed.
6: Open Odin. Then, connect your phone to the pc.
7: Odin will detect the device and show the “Added message in the lower-left panel.”.
8: Once Odin detects your device, click the PDA button, and select the Firmware.tar file.
9: Now, click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete on your Phone.
Once you see the Pass message in Odin, you can disconnect your device from the pc.
When your Galaxy J1 Ace SM-J111M finally boots up, you should run your desired firmware.
To verify the installed firmware, go to Settings –> About Phone –> Software Information. Check the firmware number under “Baseband version.”
Disclaimer:
- Read and understand the Full Guide before flashing.”Galaxy J1 Ace SM-J111M Firmware“.
- Use these instructions at your own risk. We are not liable for any outcomes on your device due to following the information in this guide.
- Phone must have a 70–80% charge.