The specific Galaxy A50 SM-A505G U9 Firmware Download Package has a Stock ROM of Galaxy A50 SM-A505G U9 Security Patch Level 2023-04-01 (April 1, 2023). This helps bypass the FRP lock and revert from the root and custom ROM.
Advertisement
Samsung Galaxy A50 SM-A505G Binary 9 Android 11 R Panama TPA A505GUBU9CWF2
There are various reasons to flash “Stock Firmware on Galaxy A50 SM-A505G U9“. For instance, if your phone gets stuck on the logo and you need to remove the FRP lock from it.
If you’re going to reset your phone hard and you cannot access the recovery menu. But most of the problems that cause flashing stock ROM are below.
The Advantages Of Stock ROM:
Fix boot loop issue
Update and Downgrade
Unroot or Fix Bugs
To solve the lag or stutter
Fix software issues.
Revert back to stock to get you.
Pre-requirements:
Supported Phone: Galaxy A50 SM-A505G U9
Charge your mobile: You may need no less than a half charge.
How To Install Galaxy A50 SM-A505G U9 Stock Firmware:
1: Download and Install Samsung USB Driver on your computer. If Samsung USB Driver is installed on your computer, Skip this Step.
2: Download and extract the Galaxy A50 SM-A505G U9 Firmwarefiles on your computer.
3: Now, Switch off your Smartphone.
4: After switching off the phone, you need to boot into Downlmuste. To boot into download mode.
Press and hold Volume Down, Home, and Power button at the same time for 5-8 seconds until download mode is active.
5: In the Download mode, you can see a Warning Yellow Triangle Sign. In this situation, you have to press the Volume Up key to continue.
6: Now, Download and open Odin. Then connect your Smartphone to the computer.
7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show the “Added” message at the lower-left panel.
8: Click the PDA button, and choose the Firmware.tar file.
9: Now click the Start button in Odin to begin the Flashing.
10: Flashing usually takes 30-50 seconds to complete the process on your Phone.
Once the Firmware process is completed, you can see a Green Box with Pass written on it in Odin; during this process, the Smartphone will reboot automatically.
Once you see the Pass message in Odin, you can disconnect your device from the pc. The flashing process will begin and should take about 10–12 minutes. It may take some time for device your device to be alarmed.
When your Galaxy A50 SM-A505G U9 finally boots up, you should now be running your desired firmware.
If you want to check that the correct firmware is installed, head to Settings –> About Phone –> Software Information. The firmware number is located under the “Baseband version.”
Disclaimer:
Read and understand the Full Guide before flashing.”Galaxy A50 SM-A505G U9 Firmware“.